TM 9-2320-365-20-3
14-2. FRONT BUMPER REPLACEMENT (CONT)
b. Installation.
(1) Position two side markers (1) on front bumper (2) with
four screws (3) and self-locking nuts (4).
(2) Tighten four self-locking nuts (4) to 18-22 lb-in. (2 N·m).
(3) Position intervehicular 12 vdc (7 pin) cable (5) on front
bumper (2) with two screws (6), lockwashers (7), and
self-locking nuts (8).
(4) Tighten two self-locking nuts (8) to 31-36 lb-in. (4 N·m).
WARNING
Front bumper weighs approximately 100
lbs (45 kgs). Use the aid of an assistant
to install front bumper. Failure to comply
may result in injury to personnel.
NOTE
Steps (5) and (6) require the aid of an
assistant.
(5) Install front bumper (2) on vehicle.
(6) Install two shackles (9) on supports (10) with pins (11).
(7) Install eight screws (12) on front bumper (2).
(8) Connect connector P52F (13) to connector J52 (14).
14-4
Change 1
