TM 9-2320-365-20-4
16-74. LATCH AND CAB LATCH BRACKETS REPLACEMENT
This task covers:
a. Latch Bracket Removal
b. Latch Bracket Installation
c. Cab Latch Bracket Removal
d. Cab Latch Bracket Installation
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Cab Support Tool (Item E-4, Appendix E)
Materials/Parts
Nuts, Self-Locking (2) (Item 149, Appendix G)
Personnel Required
(2)
a. Latch Bracket Removal.
(1) Raise cab (TM 9-2320-365-10).
(2) Install cab support tool on engine rear lifting eye (1).
(3) Lower cab until cab rests on cab support tool (TM 9-
2320-365-10).
(4) Remove three bolts (2) and washers (3) from latch
bracket (4).
NOTE
Perform step (5) on vehicles 0001 through
7167.
(5) Remove two self-locking nuts (5), screws (6), spacers
(7), washers (8), and latch bracket (4) from cab (9).
Discard self-locking nuts and spacers.
NOTE
Perform step (6) on vehicles 7168 and
higher.
(6) Remove two self-locking nuts (5), screws (6), washers
(8), and latch bracket (4) from cab (9). Discard self-
locking nuts.
Change 1
16-487
