RESISTANCE TEST
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
relay K2 socket 85.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 3041
from relay K2 socket 85 to terminal board
TB2 position 43 (para 2-40) or replace
WTEC II dashboard cable assembly (para
7-10) or WTEC III dashboard cable
assembly (para 7-11).
(1) Remove PDP cover (TM 9-2320-365-10).
(2) Remove relay K2 from PDP.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
relay K2 terminal 86.
(5) Connect negative (-) probe of multimeter to
relay K2 terminal 85 and note reading on
multimeter.
(6) If 76-99 ohms resistance is not present,
replace relay K2 (para 7-9).
Change 1 2-370.7
TM 9-2320-365-20-1
