TM 9-2320-365-20-2
2-1343
CONTINUITY TEST
(1) Remove dust cover on 110/208 VAC power IN
connector.
(2) Loosen screw in terminal board TB4.
(3) Remove wire 1499N from terminal board TB4.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
110/208 vac IN connector pin N.
(6) Connect negative (-) probe of multimeter to
terminal board TB4 wire 1499N and note
reading on multimeter.
(7) If continuity is not present, repair or replace
wire 1499N (para 2-40).
(8) Position wire 1499N in terminal board TB4.
(9) Tighten screw in terminal board TB4.
