TM 9-2320-365-20-3
7-73. FRONT INTERVEHICULAR 12 VDC (7 PIN) CABLE REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions
Batteries disconnected (para 7-48).
Tools and Special Tools
Goggles, Industrial (Item 15, Appendix C)
Tool Kit, Genl Mech (Item 44, Appendix C)
Materials/Parts
Ties, Cable, Plastic (Item 76, Appendix D)
Nut, Self-Locking (2) (Item 116, Appendix G)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
Remove plastic cable ties as required.
(1) Disconnect connector J52 (1) from connector P52F (2).
(2) Remove two self-locking nuts (3), four washers (4), two
screws (5), and front intervehicular 12vdc cable (6) from
vehicle. Discard self-locking nuts.
b. Installation.
(1) Install front intervehicular 12vdc cable (6) on vehicle with
two screws (5), four washers (4), and two self-locking
7-290
Change 1
NOTE
Install plastic cable ties as required.
(2) Connect connector J52 (1) to connector P52F (2).
End of Task.
nuts (3).
