TM 9-2320-365-20-3
8-9. TRANSMISSION OIL FILTER REPLACEMENT (CONT)
CAUTION
Use care when removing bearing cups
from universal joint. Failure to comply may
result in damage to equipment.
(9) Remove four screws (7) and two bearing cups (8) from
drive yoke (9). Discard screws.
(10) Slide drive shaft (10) from side to side and separate
universal joint (10.1) from drive yoke (9).
NOTE
Both transmission oil filters are removed the
same way. Right side transmission oil filter
shown.
(11) Remove six screws (11) from transmission oil filter cover
(12).
NOTE
Perform step (12) on transmissions SN lower
than 6510069120.
(12) Remove transmission oil filter cover (12) and trans-
mission oil filter (13) from transmission control valve
module (1).
NOTE
Perform step (13) on transmissions SN
6510069120 and higher.
(13) Remove transmission oil filter cover (12), gasket (14),
and transmission oil filter (13) from transmission control
valve module (1). Discard gasket.
(14) Remove transmission oil filter (13) from transmission oil
filter cover (12).
8-34
Change 1
