TM 9-2320-365-20-3
(17) Shut down engine (TM 9-2320-365-10).
(18) Drain primary air tank (TM 9-2320-365-10).
(19) Disconnect test cable (12) from pressure transducer
(11).
(20) Remove pressure transducer (11) from tee fitting (10).
(21) Disconnect air hose (5) from 90-degree fitting (6).
(22) Remove 90-degree fitting (6) from left rear service
brake air chamber (7).
(23) Disconnect center air hose (8) from 90-degree fitting
(9).
(24) Remove 90-degree fitting (9) from tee fitting (10).
(25) Remove tee fitting (10) from left rear service brake air
chamber (7).
WARNING
Adhesives, solvents, and sealing com-
pounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area.
If
adhesive, solvent, or sealing compound
gets on skin or clothing, wash immediately
with soap and water. Failure to comply
may result in injury to personnel.
(26) Apply antiseize compound to threads of two 90-degree
fittings (6 and 9).
(27) Install 90-degree fitting (9) in left rear service brake air
chamber (7).
(28) Connect center air hose (8) to 90-degree fitting (9).
(29) Install 90-degree fitting (6) in left rear service brake air
chamber (7).
(30) Connect air hose (5) to 90-degree fitting (6).
Change 1
11-59/(11-60 Blank)
