TM 9-2320-365-20-3
11-10. LOAD SENSING VALVE AND CONTROL CABLE REPLACEMENT/ADJUSTMENT
(CONT)
NOTE
STE/ICE-R attached to rear service brake
air chamber should indicate air pressure
within limits shown in Table 11-1. Air
Chamber Pressure Limits.
(20) Note reading on pressure gage while brake pedal is
depressed.
Table 11-1. Air Chamber Pressure Limits
Model Number
Air Pressure Limits
M1078, M1081
45-55 psi (310-379 kPa)
M1080
22-28 psi (152-193 kPa)
M1079
45-55 psi (310-379 kPa)
NOTE
• If air chamber pressure is not within limits
shown in Table 11-1. Air Chamber Pressure
Limits, perform steps (21) through (23),
depress brake pedal several times, shut down
engine, and perform steps (17) through (20)
again.
• Lengthening load sensing valve control cable
will increase pressure reading, shortening
cable will decrease pressure reading.
(21) Loosen screw (4) in cable clamp (1).
(22) Adjust length of load sensing valve control cable (13).
(23) Tighten screw (4) in cable clamp (1).
(24) Tighten jam nut (14) on screw (4).
11-58.2
Change 1
