TM 9-2320-365-20-4
16-10. FENDER AND SPLASH GUARD REPLACEMENT (CONT)
(2) Remove two self-locking nuts (6), washers (7), spacers
(8), screws (9), and bracket (10) from rear fender (4).
Discard self-locking nuts.
(3) Remove self-locking nut (11), two washers (12), and
hook (13) from rear fender (4). Discard self-locking nut.
(4) Remove nut (14) from hook (13).
h. Rear Fender Installation.
NOTE
Left and right rear fenders are installed the
same way. Right side shown.
(1) Install nut (1) on hook (2).
(2) Position hook (2) on rear fender (3) with two washers (4)
and self-locking nut (5).
(3) Tighten self-locking nut (5) to 18-22 lb-ft (24-30 N·m).
16-88
