TM 9-2320-365-20-5
(19) Remove self-locking nut (30), and washer (31) from
voltage regulator terminal (32).
(20) Position terminal lug TL35 (33) on voltage regulator
terminal (32) with washer (31), and self-locking nut (30).
(21) Tighten self-locking nut (30) to 24 lb-in. (3 N·m).
(22) Position dust boot (34) on terminal lug TL35 (33).
(23) Remove screw (35), lockwasher (36), and washer (37)
from alternator (16).
(24) Position ground strap (38), washer (37), and terminal lug
TL5 (39) on alternator (16) with lockwasher (36) and
screw (35).
(25) Tighten screw (35) to 60-84 lb-in. (7-9 N·m).
(26) Position 12vdc cable (40) and 24vdc cable (41) in engine
compartment with terminal lugs TL2 (42) and TL60 (43)
located next to alternator (16).
(27) Install dust boot (44) on 12vdc cable (40).
(28) Install dust boot (45) on 24vdc cable (41).
(29) Remove terminal lug TL6 (46) from wire (47). Discard
terminal lug.
(30) Position wire (47) in dust boot (45) with terminal lug TL2
(42).
(31) Install terminal lug TL6 (48) on wire (47).
Change 1
20-317
