CONTINUITY TEST
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
CAUTION
Change 1 2-305
TM 9-2320-365-20-1
(11) Connect batteries (para 7-48).
(1) Disconnect batteries (para 7-48).
(2) Remove instrument panel assembly for
access (para 7-15).
(3) Disconnect connector J31 from connector
P31.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter
to connector J31pin 5.
(6) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(7) If continuity is not present, repair wire
3015 from connector J31 pin 5 to terminal
board TB2 position 18 on power
distribution PDP (para 2-40) or replace
WTEC II dashboard cable assembly (para
7-10) or WTEC III dashboard cable
assembly (para 7-11).
(8) If continuity is present, repair wire 3015
from connector P31 socket 5 to terminal
lug TL29 (para 2-40) or replace engine
control cable assembly (para 7-72).
(9) Connect connector J31 to connector P31.
(10) Install instrument panel assembly (para
7-15).
